Used to do much the same thing with the old FBII XL4 except that theĮxpansion modules for it still required panel power as did all theįor alarm installers: The direct connect module just hooks up to the board keypad wiring and can connect to the laptop thru a usb port. On the main panel because it had its own power supply. How much you ran off the expansion modules it only put a single keypad load Wires (heavier gage) back to the main panel in the main building. I liked the NX8E myself because I could put a selfĬontained and self powered expansion module in another building and wireĮverything up almost like it was its own alarm panel, and then just run 4 Modules, keypads, and accessories that were on the system, but may not haveīeen at the main panel. The biggest headache you get when you do a board swap is finding any and all I used a US Robotics Sportster to download Overlord) download remotely just fie with many more readily available and The NX series of panels from Caddx (and I am pretty sure their newer I'm pretty sure NX-588E is the direct link module. Press - to program functions of the NX-8 master control panel itself.Įnter the location number you wish to display/alter, followed by the Įnter the desired new data, followed by the key.Īfter you press the key the program will advance to the next segment.Ĭhange it if needed and press to scroll on.įor more detailed instructions, see page 9 of the manual I referenced above.ĩ4 wrote in and swap out the board, much less hassle To change any item, enter programming as follows: This is the code you use to enter programming Follow the instructions for changing that value alone.Īnother significant code is the 'Go To Program' code, found in location 42. If all you want is to change the Download Access Code, that is stored in

Please be absolutely certain this is what you want to NOTE: Doing this will clear the program, requiring you to program the entire Go to page 8 andįollow the instructions for 'Loading Factory Defaults' in the center of the You want to do, click the following link for the manual. Do you want to do a 'factory default' on the NX-8 panel? If that is what

Delete zone on networx alarm system